99-05-13 RAYTHEON AIRCRAFT COMPANY (All type certificates of the affected airplanes previously held by the Beech Aircraft Corporation): Amendment 39-11061; Docket No. 98-CE-61-AD.

Applicability: The following airplane models and serial numbers, certificated in any category:

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (d) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required within the next 75 hours time-in-service (TIS) after the effective date of this AD, unless already accomplished.

To prevent a lack of fuel flow to the engine caused by incorrect positioning of the fuel selector, which could result in loss of engine power, accomplish the following:

(a) Install a placard, part number 36-920059-1, on the fuel tank selector to warn of the no-flow condition that exists between the fuel tank detents. Accomplish this installation in accordance with Raytheon Mandatory Service Bulletin No. 2670, Revision No. 1, dated May, 1998.

(b) Installing the placard, as specified in paragraph (a) of this AD, may be performed by the owner/operator holding at least a private pilot certificate as authorized by section 43.7 of the Federal Aviation Regulations (14 CFR 43.7), and must be entered into the aircraft records showing compliance with this AD in accordance with section 43.9 of the Federal Aviation Regulations (14 CFR 43.9).

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Wichita Aircraft Certification Office (ACO), 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

(e) The installation required by this AD shall be done in accordance with Raytheon Mandatory Service Bulletin No. 2670, Revision No. 1, dated May, 1998. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from the Raytheon Aircraft Company, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

(f) This amendment becomes effective on April 19, 1999.

FOR FURTHER INFORMATION CONTACT:

Mr. Scott West, Aerospace Engineer, Wichita Aircraft Certification Office, FAA, 1801 Airport Road, Mid-Continent Airport, Wichita, Kansas 67209; telephone: (316) 946-4146; facsimile: (316) 946-4407.