AIRWORTHINESS DIRECTIVE
CAA-AD-014/1999
Date of issue: February 08, 1999
HELICOPTER - CROSSTUBE ASSEMBLIES - REPLACEMENT
Applicability: Applies to all Bell Helicopter Textron Canada (BHTC) Model 206 series helicopters equipped with crosstube assemblies (crosstubes) of older design having rivet holes in the support area designated for rivet-on supports with the following, but not limited to, part numbers:
|
(i) Aeronautical Accessories Inc. |
206-321-001 and -002 |
|
(ii) Airborne Supply Inc. |
AB206-050-107-025 and -027 |
|
AB206-O50-119-005 and -007 |
|
|
(iii) Bell Helicopter |
206-050-107-011,-013,-025 and -027 |
|
206-050-119-001,-003,-005 and -007 |
|
|
206-050-134-001, -003, -005, -007, -009 and -011 |
|
|
206-050-157-001 and -003 |
|
|
206-050-169-001,-003,-011 and -013 |
|
|
206-053-109-001,-003,-005 and -007 |
|
|
206-053-119-001 and -003 |
|
|
206-053-129-009,-011,-101 and -103 |
|
|
(iv) Other manufacturers, as approved by the Federal Aviation Administration (FAA) under Parts Manufacturer Approval (PMA) |
Any of the above |
Effective date:
March 25, 1999Compliance : Required as indicated in TC AD CF-98-43
Remarks: Where applicable, the requirements of this AD must be integrated into the Aircraft´s Logbook(s). Address inquiries concerning this AD to: Civil Aviation Authority, Airworthiness Division, Ruzyne Airport, 160 08 Prague 6, Czech Republic, tel: 420 2 324086, fax: 420 2 364112.
Ing. Pavel MATOUŠEK
Director of Airworthiness Division CAA CZ